Apex Predator

I feel lethal, on the verge of frenzy. I think my mask of sanity is about to slip.

Apex Predator
+
manchannel:

Saving Private Ryan (1998)
+
Just another day of not being rich and famous
+
+
myampgoesto11:

Skull made out of cocaine by Diddo 
Ecce AnimalDimension 12 x 18 x 22 cmCompression molded Cocaine (street sourced) and Gelatin.Commissioned piece

Ecce Animal - The laboratoryIn order to prepare and analyze the purity of the accumulated ‘street’ Cocaine, I contacted pharmacists at a renowned laboratory. Below is a brief summary of the testing procedures and the lab results.We started with the presumptive SCOTT test (Cobalt(II) Thiocyanate). This was performed by dissolving Cobalt(II) Thiocyanate in a mixture of distilled water and glycerin and adding a bit of powder from the sample. The resulting solution turned blue when the powder was added. This test confirmed the presence of Cocaine. Having now proven the presence of Cocaine, The SCOTT test was followed up by High Performance Liquid Chromatography analysis (HPLC), the goal of which is to ascertain the purity level of the sample. HPLC analysis is a confirmatory test and is a separation technique commonly used in forensic drug analysis. The analysis is mainly used for the ease of sample preparation, best reproducibility and effectiveness. The goal of HPLC analysis is to isolate and identify components and compare these with known standard (benchmark) solutions.The analysis started with the preparation of the 100% Cocaine standard and sample solution. An amount of standard was dissolved in a mobile phase followed by a series of trial runs to calibrate and identify the HPLC method that gave adequate separation of the standard. After several trail runs the preferred mobile phase consisted of 20% Acetonitrile, 80% water and contained 0,1% Trifluoroacetic Acid (TFA).After calibration the sample solution was ready to be analyzed. A small volume of the sample solution was injected into the stream of mobile phase and percolated through the column of the HPLC system. The sample moves through the column at different velocities, a function of its specific physical interaction with the sorbent. The velocity of each component depends on its molecular weight, the nature of the stationary phase and the composition of the mobile phase. The time at which a specific analyte elutes is the retention time. The retention time measured under particular conditions is considered an identifying characteristic of the analyte. By comparing the retention times of the standard and the sample in the resulting Chromatograph you will identify the compound.The retention time of our sample matched the Cocaine standard, albeit with
 a much smaller peak. This is because the sample is diluted with so-called ‘cutting agents’. The purity of the Cocaine in percentage lies in the range of approximately 15% to 20%. Further constituent components identified included Phenacetin, Caffeine, Paracetamol and 
a relative large percentage of sugars, most probably Mannitol or Inositol.


My Amp Goes To 11: Twitter | Instagram
myampgoesto11:

Skull made out of cocaine by Diddo 
Ecce AnimalDimension 12 x 18 x 22 cmCompression molded Cocaine (street sourced) and Gelatin.Commissioned piece

Ecce Animal - The laboratoryIn order to prepare and analyze the purity of the accumulated ‘street’ Cocaine, I contacted pharmacists at a renowned laboratory. Below is a brief summary of the testing procedures and the lab results.We started with the presumptive SCOTT test (Cobalt(II) Thiocyanate). This was performed by dissolving Cobalt(II) Thiocyanate in a mixture of distilled water and glycerin and adding a bit of powder from the sample. The resulting solution turned blue when the powder was added. This test confirmed the presence of Cocaine. Having now proven the presence of Cocaine, The SCOTT test was followed up by High Performance Liquid Chromatography analysis (HPLC), the goal of which is to ascertain the purity level of the sample. HPLC analysis is a confirmatory test and is a separation technique commonly used in forensic drug analysis. The analysis is mainly used for the ease of sample preparation, best reproducibility and effectiveness. The goal of HPLC analysis is to isolate and identify components and compare these with known standard (benchmark) solutions.The analysis started with the preparation of the 100% Cocaine standard and sample solution. An amount of standard was dissolved in a mobile phase followed by a series of trial runs to calibrate and identify the HPLC method that gave adequate separation of the standard. After several trail runs the preferred mobile phase consisted of 20% Acetonitrile, 80% water and contained 0,1% Trifluoroacetic Acid (TFA).After calibration the sample solution was ready to be analyzed. A small volume of the sample solution was injected into the stream of mobile phase and percolated through the column of the HPLC system. The sample moves through the column at different velocities, a function of its specific physical interaction with the sorbent. The velocity of each component depends on its molecular weight, the nature of the stationary phase and the composition of the mobile phase. The time at which a specific analyte elutes is the retention time. The retention time measured under particular conditions is considered an identifying characteristic of the analyte. By comparing the retention times of the standard and the sample in the resulting Chromatograph you will identify the compound.The retention time of our sample matched the Cocaine standard, albeit with
 a much smaller peak. This is because the sample is diluted with so-called ‘cutting agents’. The purity of the Cocaine in percentage lies in the range of approximately 15% to 20%. Further constituent components identified included Phenacetin, Caffeine, Paracetamol and 
a relative large percentage of sugars, most probably Mannitol or Inositol.


My Amp Goes To 11: Twitter | Instagram
myampgoesto11:

Skull made out of cocaine by Diddo 
Ecce AnimalDimension 12 x 18 x 22 cmCompression molded Cocaine (street sourced) and Gelatin.Commissioned piece

Ecce Animal - The laboratoryIn order to prepare and analyze the purity of the accumulated ‘street’ Cocaine, I contacted pharmacists at a renowned laboratory. Below is a brief summary of the testing procedures and the lab results.We started with the presumptive SCOTT test (Cobalt(II) Thiocyanate). This was performed by dissolving Cobalt(II) Thiocyanate in a mixture of distilled water and glycerin and adding a bit of powder from the sample. The resulting solution turned blue when the powder was added. This test confirmed the presence of Cocaine. Having now proven the presence of Cocaine, The SCOTT test was followed up by High Performance Liquid Chromatography analysis (HPLC), the goal of which is to ascertain the purity level of the sample. HPLC analysis is a confirmatory test and is a separation technique commonly used in forensic drug analysis. The analysis is mainly used for the ease of sample preparation, best reproducibility and effectiveness. The goal of HPLC analysis is to isolate and identify components and compare these with known standard (benchmark) solutions.The analysis started with the preparation of the 100% Cocaine standard and sample solution. An amount of standard was dissolved in a mobile phase followed by a series of trial runs to calibrate and identify the HPLC method that gave adequate separation of the standard. After several trail runs the preferred mobile phase consisted of 20% Acetonitrile, 80% water and contained 0,1% Trifluoroacetic Acid (TFA).After calibration the sample solution was ready to be analyzed. A small volume of the sample solution was injected into the stream of mobile phase and percolated through the column of the HPLC system. The sample moves through the column at different velocities, a function of its specific physical interaction with the sorbent. The velocity of each component depends on its molecular weight, the nature of the stationary phase and the composition of the mobile phase. The time at which a specific analyte elutes is the retention time. The retention time measured under particular conditions is considered an identifying characteristic of the analyte. By comparing the retention times of the standard and the sample in the resulting Chromatograph you will identify the compound.The retention time of our sample matched the Cocaine standard, albeit with
 a much smaller peak. This is because the sample is diluted with so-called ‘cutting agents’. The purity of the Cocaine in percentage lies in the range of approximately 15% to 20%. Further constituent components identified included Phenacetin, Caffeine, Paracetamol and 
a relative large percentage of sugars, most probably Mannitol or Inositol.


My Amp Goes To 11: Twitter | Instagram
myampgoesto11:

Skull made out of cocaine by Diddo 
Ecce AnimalDimension 12 x 18 x 22 cmCompression molded Cocaine (street sourced) and Gelatin.Commissioned piece

Ecce Animal - The laboratoryIn order to prepare and analyze the purity of the accumulated ‘street’ Cocaine, I contacted pharmacists at a renowned laboratory. Below is a brief summary of the testing procedures and the lab results.We started with the presumptive SCOTT test (Cobalt(II) Thiocyanate). This was performed by dissolving Cobalt(II) Thiocyanate in a mixture of distilled water and glycerin and adding a bit of powder from the sample. The resulting solution turned blue when the powder was added. This test confirmed the presence of Cocaine. Having now proven the presence of Cocaine, The SCOTT test was followed up by High Performance Liquid Chromatography analysis (HPLC), the goal of which is to ascertain the purity level of the sample. HPLC analysis is a confirmatory test and is a separation technique commonly used in forensic drug analysis. The analysis is mainly used for the ease of sample preparation, best reproducibility and effectiveness. The goal of HPLC analysis is to isolate and identify components and compare these with known standard (benchmark) solutions.The analysis started with the preparation of the 100% Cocaine standard and sample solution. An amount of standard was dissolved in a mobile phase followed by a series of trial runs to calibrate and identify the HPLC method that gave adequate separation of the standard. After several trail runs the preferred mobile phase consisted of 20% Acetonitrile, 80% water and contained 0,1% Trifluoroacetic Acid (TFA).After calibration the sample solution was ready to be analyzed. A small volume of the sample solution was injected into the stream of mobile phase and percolated through the column of the HPLC system. The sample moves through the column at different velocities, a function of its specific physical interaction with the sorbent. The velocity of each component depends on its molecular weight, the nature of the stationary phase and the composition of the mobile phase. The time at which a specific analyte elutes is the retention time. The retention time measured under particular conditions is considered an identifying characteristic of the analyte. By comparing the retention times of the standard and the sample in the resulting Chromatograph you will identify the compound.The retention time of our sample matched the Cocaine standard, albeit with
 a much smaller peak. This is because the sample is diluted with so-called ‘cutting agents’. The purity of the Cocaine in percentage lies in the range of approximately 15% to 20%. Further constituent components identified included Phenacetin, Caffeine, Paracetamol and 
a relative large percentage of sugars, most probably Mannitol or Inositol.


My Amp Goes To 11: Twitter | Instagram
myampgoesto11:

Skull made out of cocaine by Diddo 
Ecce AnimalDimension 12 x 18 x 22 cmCompression molded Cocaine (street sourced) and Gelatin.Commissioned piece

Ecce Animal - The laboratoryIn order to prepare and analyze the purity of the accumulated ‘street’ Cocaine, I contacted pharmacists at a renowned laboratory. Below is a brief summary of the testing procedures and the lab results.We started with the presumptive SCOTT test (Cobalt(II) Thiocyanate). This was performed by dissolving Cobalt(II) Thiocyanate in a mixture of distilled water and glycerin and adding a bit of powder from the sample. The resulting solution turned blue when the powder was added. This test confirmed the presence of Cocaine. Having now proven the presence of Cocaine, The SCOTT test was followed up by High Performance Liquid Chromatography analysis (HPLC), the goal of which is to ascertain the purity level of the sample. HPLC analysis is a confirmatory test and is a separation technique commonly used in forensic drug analysis. The analysis is mainly used for the ease of sample preparation, best reproducibility and effectiveness. The goal of HPLC analysis is to isolate and identify components and compare these with known standard (benchmark) solutions.The analysis started with the preparation of the 100% Cocaine standard and sample solution. An amount of standard was dissolved in a mobile phase followed by a series of trial runs to calibrate and identify the HPLC method that gave adequate separation of the standard. After several trail runs the preferred mobile phase consisted of 20% Acetonitrile, 80% water and contained 0,1% Trifluoroacetic Acid (TFA).After calibration the sample solution was ready to be analyzed. A small volume of the sample solution was injected into the stream of mobile phase and percolated through the column of the HPLC system. The sample moves through the column at different velocities, a function of its specific physical interaction with the sorbent. The velocity of each component depends on its molecular weight, the nature of the stationary phase and the composition of the mobile phase. The time at which a specific analyte elutes is the retention time. The retention time measured under particular conditions is considered an identifying characteristic of the analyte. By comparing the retention times of the standard and the sample in the resulting Chromatograph you will identify the compound.The retention time of our sample matched the Cocaine standard, albeit with
 a much smaller peak. This is because the sample is diluted with so-called ‘cutting agents’. The purity of the Cocaine in percentage lies in the range of approximately 15% to 20%. Further constituent components identified included Phenacetin, Caffeine, Paracetamol and 
a relative large percentage of sugars, most probably Mannitol or Inositol.


My Amp Goes To 11: Twitter | Instagram
+

35-24-35
+
+
laurentnivalle:

BMW Motorrad - Editorial Shootwith Service Plan Munichphotos & editing by ​© Laurent Nivallewww.laurentnivalle.fr
laurentnivalle:

BMW Motorrad - Editorial Shootwith Service Plan Munichphotos & editing by ​© Laurent Nivallewww.laurentnivalle.fr
laurentnivalle:

BMW Motorrad - Editorial Shootwith Service Plan Munichphotos & editing by ​© Laurent Nivallewww.laurentnivalle.fr
laurentnivalle:

BMW Motorrad - Editorial Shootwith Service Plan Munichphotos & editing by ​© Laurent Nivallewww.laurentnivalle.fr
laurentnivalle:

BMW Motorrad - Editorial Shootwith Service Plan Munichphotos & editing by ​© Laurent Nivallewww.laurentnivalle.fr
laurentnivalle:

BMW Motorrad - Editorial Shootwith Service Plan Munichphotos & editing by ​© Laurent Nivallewww.laurentnivalle.fr
laurentnivalle:

BMW Motorrad - Editorial Shootwith Service Plan Munichphotos & editing by ​© Laurent Nivallewww.laurentnivalle.fr
laurentnivalle:

BMW Motorrad - Editorial Shootwith Service Plan Munichphotos & editing by ​© Laurent Nivallewww.laurentnivalle.fr
+
+
vintageclassiccars:

Abandoned love in France.
+

Hypersport | ® |